Air Tools

The 3/4″ air hose comes standard with Chicago fittings and in 50′ lengths.

3/8″ Air hose is used with small tools. 

The 6-10 CFM air compressor uses a 3/8″ hose and runs off of a Honda engine. It is used when you need to run more than one small air tool.

The air floor nailer takes L or T nails, which we sell. It connects to a 3/8″ air hose and can be run off of our 2-3 CFM air compressor.

The 2-3 CFM air compressor uses a 3/8″ hose and runs off of a standard outlet.

The chipping hammer attaches to a 3/4″ hose and must be run off of a 185 CFM air compressor. It comes with a point and chisel bit.

The 30 lbs. breaker attaches to a 3/4″ hose and must be run off of a 185 CFM air compressor. It comes with a point and chisel bit.

The 65 lbs. breaker attaches to a 3/4″ hose and must be run off of a 185 CFM air compressor. It comes with a point and chisel bit.

The 90 lbs. breaker attaches to a 3/4″ hose and must be run off of a 185 CFM air compressor. It comes with a point and chisel bit.

The pogo stick runs off of a 3/4″ hose and is perfect for removal of ceramic tile or mastic.

Powered by a 185cfm air compressor and 3/4″ air hose. This machine will drive up to a 3″ fence post in seconds.

The 90 CFM air compressor is perfect for anyone that needs to only use one air tool or blow out irrigation lines for winterization.

The 185 CFM air compressor is towed with a 2″, 2 5/16″, or a pintle hitch. It is equipped with three 3/4″ Chicago fittings. It will put out up to 140 psi and can be adjusted down for different jobs.

The Schmidt sand blaster is paired with our 185 air compressor for the best results. The sand blaster is perfect for the extra tough jobs.

Soda Blasting can be used on almost all materials and is especially helpful for cleaning up fire damage and rust around sensitive hoses. The Buster Blaster model 100 soda blaster has a capacity of 100 lbs. of Natrium Soda– that’s two bags.